Allen Auto Repair

Let's say you live in a cold climate where the snowy, icy weather challenges you to clear the salt and debris tossed up on your windshield.  You push your windshield washer switch expecting a good stream of fluid so the blades can wipe the glass clean. Yet nothing comes out.  Nada, zip.  What's going on? You know you filled up the windshield washer reservoir within the last week or so.  Well, there could be a few things causing your windshield washing system to fail.  One culprit? The hoses that are supposed to carry that fluid from the washer pump to the spray nozzles may be frozen, or maybe they're cracked and leaking. It could be the nozzles themselves are stopped up, either iced up or jammed full of debris.  Your windshield wiper/washer switch could be worn out or the electrical system may not be conducting power to the washer pump.  It's important that this system work properly, especially on days when the sun may be in front of you and your wind ... read more

When you start your vehicle’s engine, there’s another motor that makes that whole process possible.  It’s called the starter, and it’s a small electric motor that gets your vehicle running.   As you can imagine, it’s quite a chore for a little electric motor to turn over the big engine that powers your vehicle.  And after hundreds of successful starting missions, after a while, it will start to give out. You’ll know the starter is starting to give up the ghost when it turns too slowly or sometimes doesn’t do anything when you turn on the ignition.  Maybe it makes funny noises like grinding when you try to start your vehicle or maybe there’s just a click. Those are all reasons to get your vehicle over to us so we can see what’s going on.  A technician will make sure the problem is the starter and not in the battery, a switch, or other electrical component or connections.  If all of those are ruled out, y ... read more

Your vehicle's brakes wear out.  It's inevitable. You'll notice it when you step on the brake pedal and feel it harder to stop, or there's vibration when you are braking.  Most modern vehicles have disc brakes that each use a brake pad that press on a disc (disc brakes!) called a rotor.  The friction between them enables you to stop, and each time you do a little bit of the pad and the rotor wears down. The original brakes on vehicles used a rotor that was thick enough to last through at least two replacements of the pads.  But vehicle manufacturers who want to save costs and weight now make them thinner, and sometimes the rotors have to be replaced after the first pad replacement.  But not always. Vehicle manufacturers specify a minimum thickness to provide safe braking.  Sometimes rather than having to have your rotors replaced, they can be put on a lathe and resurfaced.  In other words, the surfaces of the disc can be slightly shaved off so the sur ... read more

Your vehicle may be wearing boots right now and you might not even know it.  They're called ball joint boots.  They're actually protective, flexible things that protect parts of your suspension (called ball joints) from all the hazards the road can fling at them.  If one of those ball joint boots fails and you don't get it replaced, the ball joints themselves could wind up failing, a repair that can be even more expensive.  Ball joint boots not only keep things like rocks, salt, water and dirt out of your ball joints, they also help the ball joints keep their lubrication inside and working properly.  To do that, the boots have to be made of a flexible material, sometimes rubber, sometimes a synthetic.  They do take a beating, exposed to temperature extremes and debris, and eventually they can tear or crack just because of their age.  Unless someone is keeping an eye on your ball joint boots, you may never know there's a problem.  That's why when ... read more