Allen Auto Repair

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles. That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners.  Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usu ... read more

If you have a vehicle with an automatic transmission, you probably never think about gear shifting.  When motor vehicles were invented, all of them had to be shifted manually.  But that wonderful self-shifting transmission, referred to these days as simply an “automatic,” changed everything. Automatic transmissions have a lot of moving parts, and they are bathed in a fluid that keeps them lubricated and cool. That fluid also is vital to the whole gear shifting process.  As you might imagine, the longer that fluid does its job, the more chance it has to pick up some contaminants.  Sometimes a leak will spring up in an automatic transmission.  Dirty transmission fluid or not enough of it will both create problems. It may cause your Check Engine light to come on, or your transmission may run rough and make strange noises. The best strategy is not to let it get to this point.  That means you should have your transmission fluid replaced at regular i ... read more

Driving along, your exhaust system's rumbling so loud that people turn and stare at you pass by.  You're wondering when the police are going to pull you over for illegal noise. Your mind immediately thinks, aha! A broken muffler.  Well, your exhaust system is composed of many more parts than just a muffler.  Your engine makes power because of thousands of tiny explosions from detonating fuel.  Those explosions make a racket, so engineers came up with a system that acoustically dampens that sound in addition to getting rid of harmful exhaust. In the engine is the exhaust manifold that looks like several pipes that join up into one pipe.  It directs exhaust to the catalytic converter. The catalytic converter converts harmful gases into less harmful gases using certain chemical reactions.  Then comes the muffler that has baffles inside to quiet the sounds of your engine noise.  Finally: the tailpipe. All of those pipes and parts are joined together by cl ... read more

When automakers first came out with cruise control, it was a real luxury item.  The older cruise controls used a mechanical vacuum system but it worked.  Well, some of the time.  Now days, cruise control is all electronic, thanks to computers.  It's reliable and a real convenience on long trips.  Cruise control is offered on most vehicles and standard on a lot of them.  Because it's electronic, when it breaks, it's usually some electronic component.  Your vehicle's cruise can be the victim of a blown fuse. Or your vehicle's speed sensor, which—not surprisingly—measures your vehicle's speed, can also stop working.  And that will cause your cruise to stop cruising.  Vehicles with cruise control also have a built-in feature that, when the brakes are applied, turns off the cruise.  With electronic cruise control, that happens thanks to the brake pedal switch, and if a problem develops in that switch, the cruise might not work. T ... read more

LUCAS area residents may remember when the U.S. government's “Cash for Clunkers” program made a splash on the news scene. People were offered incentives to trade in old vehicles for new, in the interest of better and improved air quality from reduced emissions.But a lot of LUCAS drivers want to hang onto their old clunkers. They're dependable and they're paid for. Owners would love to see the odometers on those vehicles turn past 200,000 miles (320,000 km), as long as the repair bills don't get too expensive.There are a lot of vehicles on TX roads that have run past the 200,000 mile (320,000 km) odometer reading. Is there something that their owners are doing that keeps these vehicles on the road? Or did they just win the “lemon lottery,” and luck out by getting a particularly good vehicle? Not surprisingly, most of these owners have something in common. They never skip an oil change. Can keeping a vehicle on the road for 200,000 miles ( ... read more

If your vehicle’s power goes to the rear wheels, then you have something called U-joints in the drivetrain. U-joints are connectors that allow the rotating power from your vehicle’s engine to deliver its power through a driveshaft to make the rear wheels rotate.  You need U-joints because the surfaces you drive on aren’t perfectly flat, and the driveshaft has to allow for some flexibility when you are traveling over uneven surfaces. As you can imagine, the U-joints have to move and flex a lot as your vehicle is going down the road.  They have bearings in them to allow that flexibility, and those bearings are lubricated when your vehicle is made.  Some U-joints have lifetime lubrication and are not designed to be serviced.  When they fail, they have to be replaced.  Others have grease fittings on them that need periodic lubricating by a technician at intervals recommended by your vehicle’s manufacturer.  There are signs you can look ... read more

When you feel your vehicle vibrating as you're driving down the road, one cause could be something you may not have ever seen: your driveshaft.  It is underneath the vehicle and most drivers don't climb under there to take a look very often.  The driveshaft is a cylindrical part that helps conduct the rotational power from your engine to your drive wheels.  If you have a four-wheel drive vehicle, you may have two driveshafts.  The drive shaft has bushings, and when they wear out, that's a likely source of the vibrations.  When the bushings are in good condition, they prevent the driveshaft from vibrating.  And if you don't get your vehicle repaired fairly soon after discovering vibrations, they'll continue to get worse and cause other components of the drivetrain to wear out. The driveshaft is, of course, only one part of the drivetrain.  It includes other parts such as axles, transmission, differentials and joints.  They all work together and ne ... read more

You may have noticed sometimes on a hot and humid day, vapor will come out of your vehicle's vents when you have the air conditioning on.  Is that something to be concerned about? Well, it depends. Sometimes that steam or vapor can be caused by water accumulating in the vent system after it has condensed.  And sometimes water can pool at the bottom of a vent.  When you turn on the blower mower, the air hits the water and may create steam or vapor that you can see in the cabin. One thing to check is if that vapor smells like anything.  If it doesn't, that's a good sign. You may be able to run the fan for a while and the issue may just go away when things dry out.  But moisture collecting in the ventilation hoses in a hot vehicle may be a breeding ground for mold, and that can have health consequences. There's another possibility. Ventilation systems often have drains to get rid of any accumulated water, and debris can sometimes clog them.  A technician can ... read more

There's lots of good information to read in books and online.  You might not know that you can also "read" your tires and learn a lot about what shape they're in and if they are in need of attention. It's important to know how your tires are doing because a tire failure can be very dangerous to you, your passengers and others on the road near you. You read your tire by looking at the surface that rides on the road, where the tread is.  Check out the outer and inner edges.  If you notice there's more wear on the inner or outer edge than on the rest of the tread, your vehicle could be out of alignment.  Wear on an inner or outer edge could mean your wheels are leaning too much to one side.  When you see this, visit our service center soon to have the alignment checked. What about if both edges are worn? That could be a sign that you don't have enough air in that tire.  In an underinflated tire, the middle is not contacting the road surface as much as the edg ... read more

If you've ever walked into your garage and noticed it smelled like gasoline, pay attention. Gasoline can be dangerous, both from the health problems fumes can cause and the fire danger gasoline presents.  There are many things that can cause a vehicle to give off a gasoline odor.  One of the easiest to track down is the gas cap.  It could be missing or it doesn't seal well any more (they do wear out).  That can also cause the Check Engine light to light up, so those are clues to tell your service advisor when you take it in for diagnosis. Another thing that can cause the Check Engine light to come on and produce a gasoline smell is the fuel filler neck. It's the part that goes from the place you put your fuel in to the gas tank. Over time, these can wear out and fail (they're made out of rubber or metal).  They can leak gasoline, too. It's always a good idea to check the garage floor for any gasoline puddles.  Note the location of the puddle in relation to ... read more